2012年5月9日 · furnace tape Furnace tape is a step up from duct tape. It is just aluminum foil with a really sticky adhesive and won't fall off over time. You can buy it everywhere and it's not too pricey. Maybe it will work. Lot's of brands. Good Luck.

2015年1月15日 · Then I printed 1:20 scale pattern on A4, cut carefully and overlapped those darts with some sticky tape. Here are results: I can't say I am happy with this shape. I am not sure if you can see from these poor-quality images, but the resulting sail has a sharp transition at maximum draft line, almost breaking there. It is not as smooth as I expected.

2009年2月12日 · Sam, I am a business process managment (BPM) consultant for many small and some very large companies. I assume you will be using project based cost accounting where the work break down structure (wbs) provides the link to an effective accounting system.

2007年12月3日 · Use that to create the raduis under the tape as others have suggested. For the tape make another small batch, just epoxy -- a small amount of filler to keep it from being too runny is OK but don't add too much or it won't infuse the glass properly. For a little job a small brush works well, for bigger jobs you want a roller.

2015年1月15日 · Then I printed out these panels on A4, cut them out carefully, and joined edge by edge with sticky tape, because at this scale, it would be nearly impossible to join these edges any other way. It was a messy job, took me more than an hour, made some mistakes on the way, but the result is very promising, compared to my dart-shaping attempts.

2011年6月26日 · Something that I found very usefull is to use stiff cardboard of A4 size and sticky tape as a basis to play with until the boat takes the shape. I have already done a double hull speedboat, tugboat, deep-v speed boat and double ended boat (like a canoe) using this method to get the shape and scale right.

2009年7月8日 · Understanding how to resolve moments can be a challenge for experienced structural designers. I have seen some world renowned engineering firms produce structures that fall apart prematurely because there was inadequate means of resolving moments. Five minutes with some cardboard and sticky tape can be illuminating.

2017年5月23日 · I am not sure about Starcraft but most riveted boats put a mastic tape, ie a thin sealing double sided sticky tape between an overlaping SEAM. If you try to weld in an area near the mastic, it will ooze out and ruin the sealing characteristics of tape Best to check for the existence of the mastic before applying heat

2018年11月4日 · Wetout more dbias tape - 20oz or 450-600sgm tape and wrap it around the uni edge to consolidate the glass ring structure to the ply. Im not sure how its bonded to the hull but if it needs extra stiffness - you can lay uni on the hull - directly adjacent the bulkhead. Then run you tabbing from the bulkhead onto the uni- which is on the hull.

2012年8月15日 · When I made one for my old mosquito beach cat I used a light unidirectional glass tape wrapped from one end to the other on a 45 degree angle then back the other way on an opposing 45 degree angle. I taped the ends in position with sticky tape the wet out then vac bagged the tapes in position while they cured it worked really well and was quite ...