Ccf stands for 100 cubic feet. So the meter is read 8953 hundred and 9035 hundred, or 895,300 cf and 903,500 cf respectively. More Info: When reading a meter, you'll notice each dial has an arrow. This arrow points the direction the needle spins. The number above the dial indicates how much the value increases, per revolution of that needle ...

2016年1月8日 · If true, from the meter shown that would be a change of around 300 cubic feet, or about 3 therms. You can check your gas bill to see how many therms per month you are averaging. During my peak heating days, I can use that much, so it's not unreasonable. For the meter to record 10000 cubic feet change in a day (or to run backward) is unreasonable.

Since every appliance has an independent cut off valve, I closed all those and the gas meter shutoff valve, used a bicycle tire pump to pressurize the system to 30 psi and waited. If the whole system does not hold pressure for hours and hours, there is a leak somewhere. At the end, the worst leak offender was the test gauge itself.

2017年11月13日 · The gas company technician has turned gas off to the gas meter because he detected .4 volts coming off the gas pipe leading to our furnace. The meter was disconnected when he tested the pipe. He stuck a screw driver in the soil to use as a ground and then put the multi meters red lead on the pipe to show .4 volts.

2022年9月2日 · The meter in question is under eaves and above a small concrete pad. The utility company needs access for visual reading and any repairs, so it should be easy to remove. It (obviously) cannot hang off the meter itself, its struts or pipes, and so it will need its own independent support.

2023年4月2日 · Interesting that this older meter can remotely report the reading. One person living near me reckons they have electromagnetic sensitivity and insisted the gas company remove its installation of remote reporting module on the gas meter. Some people refused, or tried to refuse, the installation of the new digital electronic electric meters.

2016年1月8日 · The noise is likely caused by a moving part rubbing its bearing or keeper. Whether or not it's a problem will depend on the meter. You should contact the utility, and let them decide how to proceed. In most places the utility owns the meter, and is responsible for maintaining and/or replacing them.

2023年11月22日 · In the summer we go months without heating. This gives me a baseline for what the gas water heater would use. Assuming roughly equal amounts of hot water usage summer and winter, the winter gas bill - summer gas bill = winter heating use. Right now here gas is a lot cheaper. Natural gas is about 2.25 /GJ (wholesale) to 5.50 fixed term 5 years.

Most new appliances do not have pilot lights so if they are not being used there is no gas usage. Shutting the main off even during the time the meter is being read won't trigger an inspection. In Earthquake prone areas some home owners have a wrench attached to the pipe so if there is a concern about leaks the main can be quickly turned off.

2019年5月22日 · First I would cut the problem in half as I have seen 2 different scenarios on 3 occasions over the years. Turn the power off at the main, now record the meter reading, wait an hour or longer and check the meter reading it should not have changed at all.