2013年10月17日 · You put a frame member below and above the drawer sides and glue a strip of the HPL onto the runner. You can put one on the bottom of the drawer side too if you want. …

2014年3月15日 · Mechanically- Like many DYI materials, a single drawer slide is not precision and has play, but... That depends on how many drawer slides you use and while using …

2014年3月29日 · The slides are in 2 pieces: the back 2 are glued together, and the front one is free floating. That allows me to tighten that the front down as much as needed to take up the …

2014年1月13日 · Metal slides can be installed so that they do not show at all unless you get down and look under the drawer. The big advantage to the metal slides is that you can get a 3/4, full …

2017年2月8日 · So I put a block like in the drawing. It just hangs low enough to catch the back of the drawer. My face frame is 1-1/2 inches thick (2x4) though. I guess it could hit stuff that's in …

2011年5月3日 · Using Drawer slides was a last resort until I figured out a way to keep them tight. Everything else I tried was to sloppy or so tight it wouldn't move very well. I included some …

2024年6月13日 · Did a proof of concept with drawer slides today , this way I can get access to the side fans in the future , or any wire configuration changes . I didn’t like the fact that the side …

2007年1月8日 · My slides were made of Walnut scraps about 1/4" x 3/8" x maybe 7-8". I drilled holes at each end of the, say 1/8" and a 1/16" deep counterbore of 1/4" to hide the pan-head …

2009年3月4日 · Uses a plunge router loaded with spiral upcut bits. A guide rail slides in a groove on the backside of the jig. I use PC 690 with a plunge base, PC Edge Guide, and 1/4”, 3/8” …

2013年5月18日 · The rear tan colored star type knob came from a store that sells new/used tooling and equipment, industrial supplies etc. I think the knob may have been .75 cnets or so. …